Here’s a step-by-step guide to setting up and cleaning the Salter AIRE Elite Compressor Nebulizer:

Setting Up the Salter AIRE Elite Compressor Nebulizer

1. Unpack the Nebulizer:
   • Remove the compressor and all accessories from the packaging.
   • Ensure you have all components: the compressor unit, nebulizer cup, mouthpiece or mask, tubing, and any additional accessories.
2. Place the Compressor:
   • Set the compressor on a flat, stable surface near an electrical outlet.
3. Connect the Tubing:
   • Attach one end of the tubing to the air outlet on the compressor.
   • Connect the other end of the tubing to the bottom of the nebulizer cup.
4. Prepare the Medication:
   • Open the nebulizer cup by unscrewing the top.
   • Add the prescribed amount of medication to the nebulizer cup.
   • Securely screw the top back onto the nebulizer cup.
5. Attach the Mouthpiece or Mask:
   • Connect the mouthpiece or mask to the top of the nebulizer cup.
   • If using a mask, ensure it fits comfortably on the patient’s face.
6. Power On the Compressor:
   • Plug the compressor into an electrical outlet.
   • Turn on the compressor using the power switch.
7. Begin Nebulization:
   • Instruct the patient to breathe in and out slowly through the mouthpiece or mask.
   • Continue until all the medication is nebulized, usually around 10-15 minutes.

Cleaning the Salter AIRE Elite Compressor Nebulizer

1. Disassemble the Nebulizer:
   • Turn off the compressor and unplug it from the electrical outlet.
   • Disconnect the tubing from the nebulizer cup and compressor.
   • Separate the mouthpiece or mask, nebulizer cup, and any additional parts.
2. Rinse Components:
   • Rinse the nebulizer cup, mouthpiece or mask, and any other removable parts under warm running water.
3. Wash with Soapy Water:
   • Fill a clean container with warm water and add a few drops of mild dish soap.
   • Submerge the nebulizer parts and gently wash them using a clean cloth or sponge.
   • Rinse thoroughly with warm water to remove all soap residue.
4. Disinfect the Components:
   • Prepare a solution of 1 part white vinegar to 3 parts water.
   • Soak the nebulizer parts (except tubing) in the solution for 20-30 minutes.
   • Alternatively, you can use a medical-grade disinfectant following the manufacturer’s instructions.
5. Rinse and Dry:
   • Rinse all parts thoroughly with warm water after disinfecting.
   • Shake off excess water and place the parts on a clean, dry towel.
   • Allow the parts to air dry completely before reassembling.
6. Clean the Compressor:
   • Wipe the exterior of the compressor with a damp cloth.
   • Ensure no water enters the air outlet or electrical components.
7. Store Properly:
   • Once all parts are dry, reassemble the nebulizer.
   • Store the compressor and accessories in a clean, dry place.

Additional Tips

• Tubing: Replace the tubing regularly as it is difficult to clean and may harbor bacteria.
• Frequency: Clean the nebulizer after each use and disinfect it at least once a week.
• Check Filters: Periodically check and replace the air filter of the compressor as per the manufacturer’s instructions.

Following these steps will ensure your Salter AIRE Elite Compressor Nebulizer remains in good working condition and provides effective treatment.